I'm trying this device out but not detecting properly.
http://products.z-wavealliance.org/products/2130Here is what I have done:
1) CastleOS Settings->Zwave->Add Device
2) Double-Click Quad wallmote's Action button (Inclusion using security)
Wallmote's LED goes to blinking Orange
3) After a few minutes
Orange blinking ceases, and goes off (I think this means inclusion successful)
Check CastleOS logs:
3:10:53 Z-Wave Controller Entering Inclusion Mode
3:11:08 Wall Controller:4 is a multichannel device. Querying channels...
3:11:08 Z-Wave Controller Linked to Device: Wall Controller:4
3:11:08 Z-Wave Controller has Exited Inclusion Mode
3:11:12 Received End Point Report:4
Under CastleOS Devices->ZWave
Shows up as Wall Controller:4 and has an On/Off button for each of the 4 channels.
(i.e. CastleOS thinks the Quad-Mote is a device that CastleOS can turn on/off)
I was hoping to use wallmote at least as an on/off button for CastleOS to use
to control some other device, and was hopeful it could also be used as a dimmer (finger sliding across the button).
Any recommendations?
edited by TommyLong on 5/24/2017